Reference Guide

cam-acl-egress (Configuration)
Select the FP groups for CAM access control lists for Layer 2, IPv4, and IPv6 ACLs.
S5000
Syntax
cam-acl-egress {default | l2acl number ipv4acl number ipv6acl
number}
Parameters
default Reset the egress CAM ACL entries to the default settings.
l2acl number
ipv4acl number
ipv6acl number
Allocate space to each CAM region.
Enter the CAM profile name followed by the amount of CAM
space to be allotted. The total space allocated must equal 13.
The l2acl range is 1 to 4. The ipv4acl range is 1 to 4. The
ipv6acl range is 0 to 4.
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You must save the new CAM settings to the startup-config (write-mem or copy
run start
) then reload the system for the new settings to take effect.
There are four groups total. You must allocate at least one group for L2ACL and
IPv4 ACL.
The range for the CAM profiles are 1 to 4 for l2acl. The range for the ipv6acl
profile is 0 to 10. The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
cam-optimization
Optimize CAM utilization for QoS Entries by minimizing require policy-map CAM space.
S5000
Syntax
cam-optimization [qos]
Parameters
qos Optimize CAM usage for QoS.
Defaults Disabled.
Command
Modes
CONFIGURATION
Content Addressable Memory (CAM)
397