Reference Guide

• L3 ACL (ipv4acl): 4
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 1
• L2 QoS (l2qos): 1
• L2PT (l2pt): 0
• MAC ACLs (ipmacacl): 0
• ECFMACL (ecfmacl): 0
• VMAN QoS (vman-qos): 0
• VMAN Dual QoS (vman-dual-qos): 0
• FCoE ACL (fcoeacl): 2
• iSCSI Opt ACL (iscsioptacl): 0
l2acl number
ipv4acl number
ipv6acl
numberipv4qos
number l2qos
numberl2pt
number
ipmacacl
number
ecfmacl
number
{vman-qos
number |
vman-dual-qos
number}
[fcoeacl
number]
[iscsiacl
number]
Enter the number fo FP blocks to be allocated to each CAM
region. Separate each keyword and number with a blank
space. the total allocated CAM space must equal 13.
The ipv6acl and vman–dual–qos allocations must be
entered as a factor of 2 (2, 4, 6, 8, or 10). All other CAM
regions can use either even or odd numbered numbers.
The range of memory blocks that you can allocate to each
CAM region is 0 to 10.
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Clarified block information for the S5000.
Usage
Information
You must save the new CAM settings to the startup-config (write-mem or copy
run start) then reload the system for the new settings to take effect.
The total amount of CAM space allowed is 16 FP Blocks. System flow requires three
blocks; these blocks cannot be reallocated. Therefore, the total number of
allocated blocks for all CAM regions must be 13.
396
Content Addressable Memory (CAM)