Reference Guide

IPADDR:NN Enter the IP address specific extended community in the
format IPADDR:NN (4-byte IPv4 Unicast Address:2-byte
community value).
non-trans (OPTIONAL) Enter the keywords non-trans to indicate a
non-transitive BGP extended community.
Defaults none
Command
Modes
ROUTE MAP (config-route-map)
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
If the set community rt and soo are in the same route-map entry, the behavior
defines as:
• If the rt option comes before soo, with or without the additive option, soo
overrides the communities set by rt.
• If the rt option comes after soo, without the additive option, rt overrides
the communities set by soo.
• If the rt with the additive option comes after soo, rt adds the communities
set by
soo.
Related
Commands
set extcommunity rt – sets the extended community route origins using the route-
map.
show ip bgp ipv4 extcommunity-list
Use this feature to display the IPv4 routes matching the extended community list name.
S5000
Syntax
show ip bgp [ipv4 [multicast | unicast] | ipv6 unicast]
extcommunity-list name
Parameters
multicast Enter the keyword multicast to display the multicast route
information.
unicast Enter the keyword unicast to display the unicast route
information.
ipv6 unicast Enter the keywords ipv6 unicast to display the IPv6
unicast route information.
name (OPTIONAL) Enter the name of the extcommunity-list.
Defaults none
Border Gateway Protocol IPv4 (BGPv4)
387