Reference Guide

show ip bgp dampened-paths
View BGP routes that are dampened (non-active).
S5000
Syntax
show ip bgp [ipv4 unicast] dampened-paths
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The following describes the show ip bgp damp command shown in the Example
below.
Field Description
Network Displays the network ID to which the route is dampened.
From Displays the IP address of the neighbor advertising the
dampened route.
Reuse Displays the hour:minutes:seconds until the dampened route
is available.
Path Lists all the ASs the dampened route passed through to
reach the destination network.
Example
Dell>show ip bgp damp
BGP table version is 210708, local router ID is 63.114.8.2
Status codes: s suppressed, d damped, h history, * valid, >
best
Path source: I - internal, a - aggregate, c - confed-external,
r - redistributed, n - network
Origin codes: i - IGP, e - EGP, ? - incomplete
Network From Reuse Path
Dell>
show ip bgp filter-list
View the routes that match the filter lists.
S5000
Syntax
show ip bgp ipv4 multicast filter-list as-path-name
Parameters
as-path-name Enter the name of an AS-PATH.
Border Gateway Protocol IPv4 (BGPv4)
373