Reference Guide

redistribute ospf
Redistribute OSPF routes into BGP.
S5000
Syntax
redistribute ospf process-id [[match external {1 | 2}] [match
internal]] [route-map map-name]
To stop redistribution of OSPF routes, use the no redistribute ospf
process-id command.
Parameters
process-id Enter the number of the OSPF process. The range is 1 to
65535.
match external
{1 | 2}
(OPTIONAL) Enter the keywords match external to
redistribute OSPF external routes. You can specify 1 or 2 to
redistribute those routes only.
match internal (OPTIONAL) Enter the keywords match internal to
redistribute OSPF internal routes only.
route-map
map-name
(OPTIONAL) Enter the keywords route-map followed by the
name of a configured route map.
Defaults Not configured.
Command
Modes
ROUTER BGP Address Family (conf-router_bgp_af)
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
When you enter the redistribute isis process-id command without any
other parameters, Dell Networking OS redistributes all OSPF internal routes,
external type 1 routes, and external type 2 routes. This feature is not supported by
an RFC.
This feature is not supported by an RFC.
show ip bgp ipv4 multicast
View the current MBGP routing table for the system.
S5000
Syntax
show ip bgp ipv4 multicast [detail | network [network-mask]
[length]]
Border Gateway Protocol IPv4 (BGPv4)
369