Reference Guide

network
Specify the networks for the BGP process and enter them in the BGP routing table.
S5000
Syntax
network ip-address mask [route-map map-name]
To remove a network, use the no network ip-address mask [route-map
map-name] command.
Parameters
ip-address Enter an IP address in dotted decimal format of the network.
mask
Enter the mask of the IP address in the slash prefix length
format (for example, /24).
The mask appears in command outputs in dotted decimal
format (A.B.C.D).
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the
name of an established route map.
Only the following ROUTE-MAP mode commands are
supported:
• match ip address
• set community
• set local-preference
• set metric
• set next-hop
• set origin
• set weight
If the route map is not configured, the default is deny (to
drop all routes).
Defaults Not configured.
Command
Modes
ROUTER BGP Address Family (conf-router_bgp_af)
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Dell Networking OS software resolves the network address configured by the
network command with the routes in the main routing table to ensure that the
networks are reachable using non-BGP routes and non-default routes.
Related
Commands
redistribute – redistributes routes into the BGP.
Border Gateway Protocol IPv4 (BGPv4)
367