Reference Guide

Defaults Not configured.
Command
Modes
ROUTER BGP Address Family (conf-router_bgp_af)
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
When you apply a route map to outbound routes, only routes that match at least
one section of the route map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the
characteristics in the Route map used in this command. If you identify a peer by IP
address, the Route map overwrites either the inbound or outbound policies on that
peer.
neighbor route-reflector-client
Configure a neighbor as a member of a route reflector cluster.
S5000
Syntax
neighbor {ip-address | peer-group-name} route-reflector-client
To indicate that the neighbor is not a route reflector client or to delete a route
reflector configuration, use the no neighbor ip-address | peer-group-
name
route-reflector-client command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-
name
Enter the name of the peer group.
All routers in the peer group receive routes from a route
reflector.
Defaults Not configured.
Command
Modes
ROUTER BGP Address Family (conf-router_bgp_af)
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The first time you enter this command, it configures the neighbor as a route
reflector and members of the route-reflector cluster. If you configure a route
reflector, internal BGP (IBGP) speakers do not need to be fully meshed.
When you disable all clients of a route reflector, the neighbor is no longer a route
reflector.
366
Border Gateway Protocol IPv4 (BGPv4)