Reference Guide

To delete a BGP filter, use the no neighbor [ip-address | peer-group-
name] filter-list aspath access-list-name [in | out] command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-
name
Enter the name of the peer group to apply the filter to all
routers in the peer group.
as-path-name
Enter the name of an established AS-PATH access list (up to
140 characters).
If the AS-PATH access list is not configured, the default is
permit (allow routes).
in Enter the keyword in to filter inbound BGP routes.
out Enter the keyword out to filter outbound BGP routes.
Defaults Not configured.
Command
Modes
ROUTER BGP Address Family (conf-router_bgp_af)
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Use the ip as-path access-list command in CONFIGURATION mode to
enter AS-PATH ACL mode and configure the AS-PATH filters to deny or permit BGP
routes based on information in their AS-PATH attribute.
Related
Commands
ip as-path access-list – enter AS-PATH ACL mode and configure the AS-PATH
filters.
neighbor maximum-prefix
Control the number of network prefixes received.
S5000
Syntax
neighbor {ip-address | peer-group-name} maximum-prefix maximum
[threshold] [warning-only]
To return to the default values, use the no neighbor {ip-address | peer-
group-name
} maximum-prefix maximum command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-
name
Enter the name of the peer group.
Border Gateway Protocol IPv4 (BGPv4)
363