Reference Guide

Command
History
Version 9.0(1.3) Introduced on the S5000.
timers bgp
Adjust the BGP Keep Alive and Hold Time timers.
S5000
Syntax
timers bgp keepalive holdtime
To return to the default, use the no timers bgp command.
Parameters
keepalive Enter a number for the time interval, in seconds, between
keepalive messages sent to the neighbor routers. The range
is 1 to 65535. The default is 60 seconds.
holdtime Enter a number for the time interval, in seconds, between
the last keepalive message and declaring the router dead.
The range is 3 to 65535. The default is 180 seconds.
Defaults none
Command
Modes
EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
MBGP Commands
Multiprotocol BGP (MBGP) is an enhanced BGP that enables multicast routing policy throughout the
internet and connecting multicast topologies between BGP and autonomous systems (ASs).
Dell Networking OS MBGP is implemented as per IETF RFC 1858. BGPv4 is supported on the S5000
switch.
352
Border Gateway Protocol IPv4 (BGPv4)