Reference Guide

< 1 day 00:12:23 (hours:minutes:seconds)
< 1 week 1d21h (DaysHours)
> 1 week 11w2d (WeeksDays)
State/Pfxrcd
If the neighbor is in Established stage, the number of
network prefixes received.
If a maximum limit was configured with the neighbor
maximum-prefix
command, (prfxd) appears in this column.
If the neighbor is not in Established stage, the current stage
is displayed (Idle, Connect, Active, OpenSent, OpenConfirm).
When the peer is transitioning between states and clearing
the routes received, the phrase (Purging) may appear in this
column.
If the neighbor is disabled, the phrase (Admin shut) appears
in this column.
Example
Dell#show ip bgp summary
BGP router identifier 120.10.10.1, local AS number 100
BGP table version is 34, main routing table version 34
9 network entrie(s) using 1372 bytes of memory
5 paths using 380 bytes of memory
4 denied paths using 164 bytes of memory
BGP-RIB over all using 385 bytes of memory
2 BGP path attribute entrie(s) using 168 bytes of memory
1 BGP AS-PATH entrie(s) using 39 bytes of memory
1 BGP community entrie(s) using 43 bytes of memory
2 neighbor(s) using 7232 bytes of memory
Neighbor AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/
Pfx
100.10.10.2 200 46 41 34 0 0 00:14:33 5
120.10.10.2 300 40 47 34 0 0 00:37:10 0
Dell#
show running-config bgp
Use this feature to display the current BGP configuration.
S5000
Syntax
show running-config bgp
Defaults none
Command
Modes
EXEC Privilege
Border Gateway Protocol IPv4 (BGPv4)
351