Reference Guide

neighbor 123.34.55.123 peer-group suzanne
neighbor 123.34.55.123 shutdown
Dell(conf-router_bgp)#
Related
Commands
capture bgp-pdu max-buffer-size – specifies a size for the capture buffer.
show ip bgp
View the current BGP IPv4 routing table for the system.
S5000
Syntax
show ip bgp [ipv4 unicast] [network [network-mask] [longer-
prefixes]]
Parameters
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 unicast to view
information only related to ipv4 unicast routes.
network (OPTIONAL) Enter the network address (in dotted decimal
format) of the BGP network to view information only on that
network.
network-mask (OPTIONAL) Enter the network mask (in slash prefix format)
of the BGP network address.
longer-prefixes (OPTIONAL) Enter the keywords longer-prefixes to view
all routes with a common prefix.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
When you enable the bgp non-deterministic-med command, the show ip
bgp
command output for a BGP route does not list the INACTIVE reason.
The following describes the show ip bgp command shown in the Example
below.
Field Description
Network Displays the destination network prefix of each BGP route.
Next Hop Displays the next hop address of the BGP router. If 0.0.0.0 is
listed in this column, then local routes exist in the routing
table.
Metric Displays the BGP route’s metric, if assigned.
Border Gateway Protocol IPv4 (BGPv4)
323