Reference Guide

Parameters
connected Enter the keyword connected to redistribute routes from
physically connected interfaces.
static
Enter the keyword static to redistribute manually
configured routes.
These routes are treated as incomplete routes.
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the
name of an established route map.
Only the following ROUTE-MAP mode commands are
supported:
• match ip address
• set community
• set local-preference
• set metric
• set next-hop
• set origin
• set weight
If the route map is not configured, the default is deny (to
drop all routes).
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
With Dell Networking OS version 8.3.1.0 and later, you can use the redistribute
command to advertise the IGP cost as the MED on redistributed routes. When you
set the route-map with metric-type internal and applied outbound to an EBGP
peer/peer-group, the advertised routes corresponding to those peer/peer-group
have the IGP cost set as MED.
If you do not configure the default-metric command, in addition to the
redistribute command, or there is no route map to set the metric, the metric
for redistributed static and connected is “0”.
To redistribute the default route (0.0.0.0/0), configure the neighbor default-
originate command.
Related
Commands
neighbor default-originate – injects the default route.
320
Border Gateway Protocol IPv4 (BGPv4)