Reference Guide

CAUTION: Inbound update storage is a memory-intensive operation. The
entire BGP update database from the neighbor is stored in memory
regardless of the inbound policy results applied on the neighbor.
NOTE: This command is supported in BGP Router Configuration mode for
IPv4 Unicast address only.
Related
Commands
show ip bgp neighbors – displays routes received by a neighbor.
neighbor subnet
Enable passive peering so that the members of the peer group are dynamic.
S5000
Syntax
neighbor peer-group-name subnet subnet-number mask
To remove passive peering, use the no neighbor peer-group-name subnet
subnet-number mask command.
Parameters
subnet-number
Enter a subnet number in dotted decimal format (A.B.C.D.) as
the allowable range of addresses included in the Peer group.
To allow all addresses, enter 0.0.0.0/0.
mask Enter a prefix mask in / prefix-length format (/x).
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
Version 9.0(1.3) Introduced on the S5000.
neighbor timers
Set keepalive and hold time timers for a BGP neighbor or a peer group.
S5000
Syntax
neighbor {ip-address | peer-group-name} timers keepalive
holdtime
To return to the default values, use the no neighbor {ip-address | peer-
group-name} timers command.
Border Gateway Protocol IPv4 (BGPv4)
315