Reference Guide

Related
Commands
bgp client-to-client reflection – enables route reflection between the route
reflector and the clients.
neighbor send-community
Send a COMMUNITY attribute to a BGP neighbor or peer group. A COMMUNITY attribute indicates that
all routes with that attribute belong to the same community grouping.
S5000
Syntax
neighbor {ip-address | peer-group-name} send-community
To disable sending a COMMUNITY attribute, use the no neighbor {ip-address
| peer-group-name} send-community command.
Parameters
ip-address Enter the IP address of the peer router in dotted decimal
format.
peer-group-
name
Enter the name of the peer group to send a COMMUNITY
attribute to all routers within the peer group.
Defaults Not configured and COMMUNITY attributes are not sent to neighbors.
Command
Modes
ROUTER BGP
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
To configure a COMMUNITY attribute, use the set community command in
ROUTE-MAP mode.
neighbor shutdown
Disable a BGP neighbor or peer group.
S5000
Syntax
neighbor {ip-address | peer-group-name} shutdown
To enable a disabled neighbor or peer group, use the neighbor {ip-address |
peer-group-name} no shutdown command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
Border Gateway Protocol IPv4 (BGPv4)
313