Reference Guide

• neighbor filter-list
• neighbor next-hop-self
• neighbor route-map
• neighbor route-reflector-client
• neighbor send-community
A neighbor may keep its configuration after it was added to a peer group if the
neighbor’s configuration is more specific than the peer group’s, and the neighbor’s
configuration does not affect outgoing updates.
A peer group must exist before you add a peer to it. If the peer group is disabled
(shutdown) the peers within the group are also disabled (shutdown).
Related
Commands
clear ip bgp – resets BGP sessions.
neighbor peer-group (creating group) – creates a peer group.
show ip bgp peer-group – views BGP peers.
show ip bgp neighbors – views BGP neighbors configurations.
neighbor peer-group (creating group)
Allows you to create a peer group and assign it a name.
S5000
Syntax
neighbor peer-group-name peer-group
To delete a peer group, use the no neighbor peer-group-name peer-group
command.
Parameters
peer-group-
name
Enter a text string up to 16 characters long as the name of
the peer group.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
When you create a peer group, it is disabled (Shut mode).
Related
Commands
neighbor peer-group (assigning peers) – assigns routers to a peer group.
neighbor remote-as – assigns a indirectly connected AS to a neighbor or peer
group.
neighbor shutdown – disables a peer or peer group.
308
Border Gateway Protocol IPv4 (BGPv4)