Reference Guide

capture bgp-pdu neighbor
Enable capture of an IPv4 BGP neighbor packet.
S5000
Syntax
capture bgp-pdu neighbor ipv4-address direction {both | rx |
tx}
To disable capture of the IPv4 BGP neighbor packet, use the no capture bgp-
pdu neighbor ipv4-address command.
Parameters
ipv4-address Enter the IPv4 address of the target BGP neighbor.
direction {both
| rx | tx}
Enter the keyword direction and a direction—either rx for
inbound, tx for outbound, or both.
Defaults Not configured.
Command
Modes
EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
capture bgp-pdu max-buffer-size – specifies a size for the capture buffer.
show capture bgp-pdu neighbor – displays BGP packet capture information.
clear ip bgp
Reset BGP sessions on the S5000. The soft parameter (BGP Soft Reconfiguration) clears the policies
without resetting the TCP connection.
S5000
Syntax
clear ip bgp * | as-number [soft [in | out] | ip-address [soft
[in | out]] | dampening | flap-statistics | ipv4 | ipv6 | peer-
group ]
Parameters
* Enter an asterisk ( * ) to reset all BGP sessions.
as-number Enter the AS number to reset all neighbors belonging to that
AS. If used without a qualifier, the keyword resets all
neighbors belonging to that AS. The range is 0 to 65535 (2-
byte), 1 to 4294967295 (4-byte), or 0.1 to 65535.65535
(dotted format).
ip-address Enter an IP address in dotted decimal format to reset all
prefixes from that neighbor.
284
Border Gateway Protocol IPv4 (BGPv4)