Reference Guide

bgp client-to-client reflection
Allows you to enable route reflection between clients in a cluster.
S5000
Syntax
bgp client-to-client reflection
To disable client-to-client reflection, use the no bgp client-to-client
reflection command.
Defaults Enabled when a route reflector is configured.
Command
Modes
ROUTER BGP
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Route reflection to clients is not necessary if all client routers are fully meshed.
Related
Commands
bgp cluster-id – assigns an ID to a BGP cluster with two or more route reflectors.
neighbor route-reflector-client – configures a route reflector and clients.
bgp cluster-id
Assign a cluster ID to a BGP cluster with more than one route reflector.
S5000
Syntax
bgp cluster-id {ip-address | number}
To delete a cluster ID, use the no bgp cluster-id {ip-address | number}
command.
Parameters
ip-address Enter an IP address as the route reflector cluster ID.
number Enter a route reflector cluster ID as a number from 1 to
4294967295.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
Version 9.0(1.3) Introduced on the S5000.
272
Border Gateway Protocol IPv4 (BGPv4)