Reference Guide

set metric-type – specifies the route type assigned to redistributed routes.
set weight
Configure a filter to add a non-RFC compliant attribute to the BGP route to assist with route selection.
S5000
Syntax
set weight weight
Parameters
weight Enter a number as the weight to be used by the route
meeting the route map specification. The range is 0 to
65535. The default is router-originated = 32768 and all other
routes = 0.
When there are multiple routes to the same destination,
routes with a higher weight are preferred.
Defaults router-originated = 32768; all other routes = 0
Defaults Not configured.
Command
Modes
ROUTE-MAP
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
If you do not use the set weight command, router-originated paths have a
weight attribute of 32768 and all other paths have a weight attribute of zero.
show config
Display the current route map configuration.
S5000
Syntax
show config
Command
Modes
ROUTE-MAP
Command
History
Version 9.0(1.3) Introduced on the S5000.
Example
Dell(config-route-map)#show config
!
Access Control Lists (ACL)
251