Reference Guide

monitor (OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL
in which you are creating the rule is applied to the monitored
interface.
NOTE: For more information, refer to the Flow-based
Monitoring section in the Port Monitoring chapter of the
Dell Networking OS Configuration Guide.
Defaults Not configured.
Command
Modes
CONFIGURATION-MAC ACCESS LIST-STANDARD
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
When you use the log option, the CP processor logs details about the packets that
match. Depending on how many packets match the log entry and at what rate, the
CP may become busy as it has to log these packets’ details.
NOTE: When ACL logging and byte counters are configured simultaneously,
byte counters may display an incorrect value. Configure packet counters with
logging instead.
Related
Commands
deny – configures a filter to drop packets.
permit – configures a filter to forward packets.
IP Prefix List Commands
When you create an access-list without any rule and then apply it to an interface, the ACL behavior
reflects implicit permit.
To configure or enable IP prefix lists, use these commands.
clear ip prefix-list
Reset the number of times traffic mets the conditions (“hit” counters) of the configured prefix lists.
S5000
Syntax
clear ip prefix-list [prefix-name]
Parameters
prefix-name (OPTIONAL) Enter the name of the configured prefix list to
clear only counters for that prefix list, up to 140 characters
long.
Access Control Lists (ACL)
229