Reference Guide

Command
Modes
CONFIGURATION-MAC ACCESS LIST-STANDARD
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
When you use the log option, the CP processor logs detail the packets that match.
Depending on how many packets match the log entry and at what rate, the CP
may become busy as it has to log these packets’ details.
NOTE: When ACL logging and byte counters are configured simultaneously,
byte counters may display an incorrect value. Configure packet counters with
logging instead.
Related
Commands
permit – configures a MAC address filter to pass packets.
seq – configures a MAC address filter with a specified sequence number.
mac access-list standard
Name a new or existing MAC access control list (MAC ACL) and enter MAC ACCESS LIST mode to
configure a standard MAC ACL. Also refer to the Commands Common to all ACL Types section and the
Common MAC Access List Commands section.
S5000
Syntax
mac access-list standard mac-list-name
Parameters
mac-list-name Enter a text string as the name of the standard MAC access
list (140 character maximum).
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Dell Networking OS supports one ingress and one egress MAC ACL per interface.
The number of entries allowed per ACL is hardware-dependent. For detailed
specifications on entries allowed per ACL, refer to your switch documentation.
Example
Dell(conf)#mac-access-list access-list standard TestMAC
Dell(config-std-macl)#?
deny Specify packets to reject
description List description
exit Exit from access-list configuration mode
no Negate a command or set its defaults
permit Specify packets to forward
remark Specify access-list entry remark
220
Access Control Lists (ACL)