Reference Guide

Parameters
ip Enter the keyword ip to configure a generic IP access list.
The keyword ip specifies that the access list will permit all IP
protocols.
ip-protocol-
number
Enter a number from 0 to 255 to permit based on the
protocol identified in the IP protocol header. The range is
from 0 to 128.
source Enter the IP address in dotted decimal format of the network
from which the packet was sent.
mask (OPTIONAL) Enter a network mask in /prefix format (/x) or
A.B.C.D. The mask, when specified in A.B.C.D format, may be
either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject
to the filter.
host ip-address Enter the keyword host and then enter the IP address to
specify a host IP address or hostname.
destination Enter the IP address of the network or host to which the
packets are sent.
count (OPTIONAL) Enter the keyword count to count packets
processed by the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes
processed by the filter.
dscp (OPTIONAL) Enter the keyword dcsp to match to the IP
DCSCP values.
order (OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where
0 is the highest priority and 254 is the lowest; lower order
numbers have a higher priority). If you do not use the
keyword order, the ACLs have the lowest order by default
(255).
monitor (OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL
in which you are creating the rule is applied to the monitored
interface.
NOTE: For more information, refer to the Flow-based
Monitoring section in the Port Monitoring chapter of the
Dell Networking OS Configuration Guide.
fragments Enter the keyword fragments to use ACLs to control packet
fragments.
Defaults Not configured.
Access Control Lists (ACL)
205