Reference Guide

in | out Identify whether ACL is applied on the ingress or egress side.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Field Description
“Extended IP...” Displays the name of the IP ACL.
“seq 5...” Displays the filter. If the keywords count or byte were
configured in the filter, the number of packets or bytes
processed by the filter is displayed at the end of the line.
“order 4” Displays the QoS order of priority for the ACL entry.
Example
Dell#show ip accounting access FILTER1 interface te 1/6
Extended IP access list FILTER1
seq 5 deny ip any 191.1.0.0 /16 count (0x00 packets)
seq 10 deny ip any 191.2.0.0 /16 order 4
seq 15 deny ip any 191.3.0.0 /16
seq 20 deny ip any 191.4.0.0 /16
seq 25 deny ip any 191.5.0.0 /16
Standard IP ACL Commands
When you create an ACL without any rule and then apply it to an interface, the ACL behavior reflects an
implicit permit.
NOTE: Also refer to the Commands Common to all ACL Types and Common IP ACL Commands
sections.
deny
Configure a filter to drop packets with a certain IP address.
S5000
Syntax
deny {source [mask] | any | host ip-address} [count [byte] |
log] [dscp value] [order] [monitor] [fragments]
To remove this filter, you have two choices:
• Use the no seq sequence-number command if you know the filter’s
sequence number.
Access Control Lists (ACL)
189