Reference Guide

Parameters
access-list-
name
Enter the name of a configured access list, up to 140
characters.
in Enter the keyword in to apply the ACL to incoming traffic.
implicit-permit (OPTIONAL) Enter the keyword implicit-permit to
change the default action of the ACL from implicit-deny to
implicit-permit (that is, if the traffic does not match the filters
in the ACL, the traffic is permitted instead of dropped).
vlan vlan-id (OPTIONAL) Enter the keyword vlan followed by the ID
numbers of the VLANs.
Defaults Not enabled.
Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You can assign one ACL (standard or extended ACL) to an interface.
NOTE: This command does not support S5000 Loopback interfaces.
When you apply an ACL that filters IGMP traffic, all IGMP traffic is redirected to the
CPUs and soft-forwarded, if required, in the following scenarios:
• on a Layer 2 interface - if a Layer 3 ACL is applied to the interface
• on a Layer 3 port or on a Layer 2/Layer 3 port
Related
Commands
ip access-list standard – configures a standard ACL.
ip access-list extended – configures an extended ACL.
show ip access-lists
Display all of the IP ACLs configured in the system, whether or not they are applied to an interface, and
the count of matches/mismatches against each ACL entry displayed.
S5000
Syntax
show ip access-lists [access-list-name] [interface type slot/
port] [in | out]
Parameters
access-list-
name
Enter the name of a configured MAC ACL, up to 140
characters.
interface type
slot/port
Enter the interface keyword followed by the interface
type and slot/port or number information. Valid slot numbers
Access Control Lists (ACL)
187