Reference Guide

Defaults Not enabled.
Command
Modes
• CONFIGURATION-STANDARD-ACCESS-LIST
• CONFIGURATION-EXTENDED-ACCESS-LIST
• CONFIGURATION-MAC ACCESS LIST-STANDARD
• CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command
History
Version 9.0(1.3) Introduced on the S5000.
remark
Enter a description for an ACL entry.
S5000
Syntax
remark [remark-number] [description]
Parameters
remark-
number
Enter the remark number. The range is from 0 to
4294967290.
NOTE: You can use the same sequence number for the
remark and an ACL rule.
description Enter a description of up to 80 characters.
Defaults Not configured.
Command
Modes
• CONFIGURATION-STANDARD-ACCESS-LIST
• CONFIGURATION-EXTENDED-ACCESS-LIST
• CONFIGURATION-MAC ACCESS LIST-STANDARD
• CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The remark command is available in each ACL mode. You can configure up to
4294967290 remarks in a given ACL.
The example below shows the use of the remark command twice within
CONFIGURATION-STANDARD-ACCESS-LIST mode. The same sequence number
was used for the remark and for an associated ACL rule. The remark precedes the
rule in the running-config because it is assumed that the remark is for the rule with
the same sequence number, or the group of rules that follow the remark.
Example
Dell(config-std-nacl)#remark 10 Deny rest of the traffic
Dell(config-std-nacl)#remark 5 Permit traffic from XYZ Inc.
184
Access Control Lists (ACL)