Reference Guide

You can display the CoS mapping information applied to traffic from authenticated
supplicants on 802.1X-enabled ports that are in Single-Hot, Multi-Host, and Multi-
Supplicant authentication modes.
Example
Dell#show dot1x cos-mapping interface tengigabitethernet 2/21
802.1p CoS re-map table on Te 2/21:
----------------------------------
Dot1p Remapped Dot1p
0 7
1 6
2 5
3 4
4 3
5 2
6 1
7 0
Dell#show dot1x cos-mapping int te 2/21 mac-address
00:00:01:00:07:00
802.1p CoS re-map table on Te 2/21:
----------------------------------
802.1p CoS re-map table for Supplicant: 00:00:01:00:07:00
Dot1 Remapped Dot1p
0 7
1 6
2 5
3 4
4 3
5 2
6 1
7 0
show dot1x interface
Display the 802.1X configuration of an interface.
S5000
Syntax
show dot1x interface type slot/port [mac-address mac-address]
Parameters
interface type
slot/port
Enter the interface keyword followed by the interface
type and slot/port or number information. Valid slot numbers
are 0-11. The valid port numbers for each interface type are
listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
802.1X
167