Reference Guide

Usage
Information
If no options are specified, debug is active on all interfaces and all VRRP groups.
show vrrp ipv6
View the IPv6 VRRP groups that are active. If no VRRP groups are active, the Dell Networking OS returns
No Active VRRP group.
S5000
Syntax
show vrrp ipv6 [vrid] [interface-type slot/port] [brief]
Parameters
vrid (OPTIONAL) Enter the virtual router identifier for the VRRP
group to view only that group. The range is 1 to 255.
interface-type
slot/port
Enter the interface type followed by slot/port or number
information. Valid slot numbers are 0-11. The valid port
numbers for each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed
by a VLAN id number from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a table of
information on the VRRP groups on the S5000.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The following describes output from the show vrrp ipv6 command shown in
the Example below.
Line beginning
with
Description
TenGigabitEthe
rnet...
Displays the Interface, the VRRP group ID, and the network
address. If the interface is no sending VRRP packets, 0.0.0.0
appears as the network address.
1398
Virtual Router Redundancy Protocol (VRRP)