Reference Guide

Defaults 0
Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This command applies to all the VRRP configured interfaces on a system. When
used in conjunction with the vrrp delay minimum CLI, the later timer rules the
VRRP enabling. For example, if
vrrp delay reload is 600 and the vrrp delay
minimum
is 300:
• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up
VRRP on all interfaces that are up and configured for VRRP.
• When an interface comes up, whether as part of a system reload or an interface
reload, the system waits 300 seconds (5 minutes) to bring up VRRP on that
interface.
You must save the configuration and reload the system for the delay timers to take
affect.
Related
Command
vrrp delay minimum – sets the delay time for VRRP initialization after a stack-unit
reboot.
vrrp-group
Assign a VRRP ID to an interface. You can configure up to 12 VRRP groups per interface.
S5000
Syntax
vrrp-group vrrp-id
Parameters
vrrp-id Enter a number as the group ID. The range is 1 to 255.
Defaults Not configured.
Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The VRRP group only becomes active and sends VRRP packets when a virtual IP
address is configured. When you delete the virtual address, the VRRP group stops
sending VRRP packets.
Related
Command
virtual-address – assigns up to 12 virtual IP addresses per VRRP group.
Virtual Router Redundancy Protocol (VRRP)
1395