Reference Guide

Command
History
Version 9.0(1.3) Introduced on the S5000.
priority
Specify a VRRP priority value for the VRRP group. This value is used by the VRRP protocol during the
MASTER election process.
S5000
Syntax
priority priority
To return to the default value, use the no priority command.
Parameters
priority Enter a number as the priority. Enter 255 only if the router’s
virtual address is the same as the interface’s primary IP
address (that is, the router is the OWNER). The range is 1 to
255. The default is 100.
Defaults 100
Command
Modes
VRRP
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
To guarantee that a VRRP group becomes MASTER, configure the VRRP group’s
virtual address with same IP address as the interface’s primary IP address and
change the priority of the VRRP group to 255.
If you set the priority command to 255 and the virtual-address is not equal
to the interface’s primary IP address, an error message appears.
show config
View the non-default VRRP configuration.
S5000
Syntax
show config [verbose]
Parameters
verbose (OPTIONAL) Enter the keyword verbose to view all VRRP
group configuration information, including defaults.
1388
Virtual Router Redundancy Protocol (VRRP)