Reference Guide

Command
History
Version 9.0(1.3) Introduced on the S5000.
debug vrrp
Allows you to enable debugging of VRRP.
S5000
Syntax
debug vrrp [vrrp-id] | [interface-type slot/port] | [interface]
| {all | packets | state | timer}
To disable debugging, use the no debug vrrp [interface-type slot/port]
| [interface][
vrrp-id] {all | packets | state | timer} command.
Parameters
interface-type
slot/port
Enter the interface type followed by slot/port or number
information to turn on debugging for specific interfaces.
Valid slot numbers are 0-11. The valid port numbers for each
interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed
by a VLAN id number from 1 to 4094.
interface Enter the interface keyword to enable debugging of all
groups on all interfaces.
vrrp-id (OPTIONAL) Enter a number from 1 to 255 as the VRRP
group ID.
all Enter the keyword all to enable debugging of all VRRP
groups.
bfd Enter the keyword bfd to enable debugging of all VFFP BFD
interactions.
packets Enter the keyword packets to enable debugging of VRRP
control packets.
state Enter the keyword state to enable debugging of VRRP state
changes.
timer Enter the keyword timer to enable debugging of the VRRP
timer.
Virtual Router Redundancy Protocol (VRRP)
1385