Reference Guide

• Probe count = 3
• 30 hops max
• 40 byte packet size
• UDP port = 33434
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
When you enter the traceroute command without specifying an IP address
(Extended Traceroute), you are prompted for a target and source IP address,
timeout (in seconds) (default is
5), a probe count (default is 3), minimum TTL
(default is 1), maximum TTL (default is 30), and port number (default is 33434). To
keep the default setting for those parameters, press the ENTER key.
For the source IP address option, you may enter IPv6 global addresses only
(link-local addresses are not supported).
For IPv6, you are prompted for a minimum hop count (default is 1) and a maximum
hop count (default is 64).
Example
(name )
Dell#traceroute www.dell.com
Translating "www.dell.com"...domain server (10.11.0.1) [OK]
Type Ctrl-C to abort.
-----------------------------------------------------------
Tracing the route to www.dell.com (10.11.84.18),
30 hops max, 40 byte packets
-----------------------------------------------------------
TTL Hostname Probe1 Probe2 Probe3
1 10.11.199.190 001.000 ms 001.000 ms 002.000 ms
2 gwegress-sjc-02.dell.com (10.11.30.126) 005.000 ms 001.000
ms 001.000 ms
3 fw-sjc-01.dell.com (10.11.127.254) 000.000 ms 000.000 ms
000.000 ms
4 www.dell.com (10.11.84.18) 000.000 ms 000.000 ms 000.000 ms
Dell#
Example (IPv4)
Dell#traceroute 10.1.1.1
Type Ctrl-C to abort.
---------------------------------------------------------------
Tracing the route to 10.11.197.31, 30 hops max, 40 byte packets
---------------------------------------------------------------
TTL Hostname Probe1 Probe2 Probe3
1 10.1.1.1 0000000 ms 0000000 ms 0000000 ms
Dell#
Example (IPv6)
Dell#traceroute 100::1
Type Ctrl-C to abort.
138
Control and Monitoring