Reference Guide

Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
traceroute
View a packet’s path to a specific device.
S5000
Syntax
traceroute {host | ip-address | ipv6-address | outgoing-
interface}
Parameters
host Enter the name of device.
ip-address Enter the IP address of the device in dotted decimal format.
ipv6-address Enter the IPv6 address, in the x:x:x:x::x format, to which you
are testing connectivity.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros. Only one occurrence of this notation is
permitted in an IPv6 address.
outgoing-
interface
(IPv6 link-local address) Enter one of the following interface
types and slot/port or number information. Valid slot
numbers are 0-11. The valid port numbers for each interface
type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Management interface, enter the keyword
managementethernet followed by slot/port numbers.
The port is 0.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed
by a VLAN id number from 1 to 4094.
Defaults
• Timeout = 5 seconds
Control and Monitoring
137