Reference Guide

* 1 Inactive
2 Active M Te 13/13
M Te 13/0-2
3 Active M Po1(Te 13/14-15)
M Te 13/18
M Te 13/3
4 Active M Po1(Te 13/14-15)
M Te 13/18
M Te 13/4
5 Active M Po1(Te 13/14-15)
M Te 13/18
M Te 13/5
Dell#
vlan-stack dot1p-mapping
Map C-Tag dot1p values to a S-Tag dot1p value. C-Tag values may be separated by commas and dashed
ranges are permitted. Dynamic mode CoS overrides any Layer 2 QoS configuration in case of conflicts.
S5000
Syntax
vlan-stack dot1p-mapping c-tag-dot1p values sp-tag-dot1p value
Parameters
c-tag-dot1p
value
Enter the keyword c-tag-dot1p followed by the customer
dot1p value that will be mapped to a service provider do1p
value. The range is 0 to 7.
sp-tag-dot1p
value
Enter the keyword sp-tag-dot1p followed by the service
provider dot1p value. The range is 0 to 7.
Defaults none
Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
vlan-stack protocol-type
Define the stackable VLAN tag protocol identifier (TPID) for the outer VLAN tag (also called the VMAN
tag). If you do not configure this command, Dell Networking OS assigns the value 0x9100.
S5000
Syntax
vlan-stack protocol-type number
1366
VLAN Stacking