Reference Guide

vlan-stack access
Specify a Layer 2 port or port channel as an access port to the stackable VLAN network.
S5000
Syntax
vlan-stack access
To remove access port designation, use the no vlan-stack access command.
Defaults Not configured.
Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Prior to enabling this command, you must enter the switchport command to
place the interface in Layer 2 mode.
To remove the access port designation, the port must be removed (using the no
member interface command) from all stackable VLAN enabled VLANs.
vlan-stack compatible
Enable the stackable VLAN feature on a VLAN.
S5000
Syntax
vlan-stack compatible
To disable the Stackable VLAN feature on a VLAN, use the no vlan-stack
compatible
command.
Defaults Not configured.
Command
Modes
CONF-IF-VLAN
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You must remove the members prior to disabling the stackable VLAN feature.
To view the stackable VLANs, use the show vlan command in EXEC Privilege
mode. Stackable VLANs contain members, designated by the M in the Q column of
the command output.
Example
Dell#show vlan
Codes: * - Default VLAN, G - GVRP VLANs
NUM Status Q Ports
VLAN Stacking
1365