Reference Guide

• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number from 1 to 128.
Defaults Not configured.
Command
Modes
CONF-IF-VLAN
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You must enable the stackable VLAN (using the vlan-stack compatible
command) on the VLAN prior to adding a member to the VLAN.
Related
Commands
vlan-stack compatible – enables stackable VLAN on a VLAN.
show interfaces dei-honor
Display the dei honor configuration.
S5000
Syntax
show interfaces dei-honor [interface-type slot/port | stack—
unit unit-number port-set number]
Parameters
interface-type
slot/port
Enter the interface keyword followed by the interface
type and slot/port or number information. Valid slot numbers
are 0-11. The valid port numbers for each interface type are
listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
stack-unit unit-
number port-
set number
Enter the keywords stack-unit followed by the unit
number. The range is 0 to 11. Then enter the keywords
port-set followed by the port-pipe number.
1362
VLAN Stacking