Reference Guide

NOTE: The :: notation specifies successive hexadecimal
fields of zeros. Only one occurrence of this notation is
permitted in an IPv6 address.
word /source-
interface
(OPTIONAL) Enter a word followed by the /source
interface keyword, then enter the interface type and slot/
port or number information. Valid slot numbers are 0-11. The
valid port numbers for each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Management interface, enter the keyword
managementethernet followed by slot/port numbers.
The port is 0.
• For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed
by a VLAN id number from 1 to 4094.
Defaults Not configured.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Telnet to link-local addresses is not supported.
terminal length
Configure the number of lines displayed on the terminal screen.
S5000
Syntax
terminal length screen-length
Parameters
screen-length Enter a number of lines. Entering zero causes the terminal to
display without pausing. The range is from 0 to 512.
Defaults 24 lines
136
Control and Monitoring