Reference Guide

Defaults none
Command
Modes
UPLINK-STATE-GROUP
Command
History
Version 9.0(1.3) Introduced on the S5000.
Example
Dell(conf-uplink-state-group-16)# description test
Dell(conf-uplink-state-group-16)#
Related
Commands
uplink-state-group – creates an uplink-state group and enables the tracking of
upstream links.
downstream
Assign a port or port-channel to the uplink-state group as a downstream interface.
S5000
Syntax
downstream interface-type slot/port
To delete an uplink-state group, enter the no downstream interface
command.
Parameters
interface-type
slot/port
Enter the interface type and slot/port or number information.
Valid slot numbers are 0-11. The valid port numbers for each
interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
Where port-range and port-channel-range specify a
range of ports separated by a dash (-) and/or individual
ports/port channels in any order; for example:
tengigabitethernet 1/1-2,5,9,11-12 port-
channel 1-3,5. A comma is required to separate each port
and port-range entry.
Defaults none
Command
Modes
UPLINK-STATE-GROUP
Uplink Failure Detection (UFD)
1351