Reference Guide

57
System Time and Date
The commands in this chapter configure time values on the system, either using the Dell Networking OS,
or the hardware, or using the network time protocol (NTP). With NTP, the switch can act only as a client
to an NTP clock host.
For more information, refer to the “Network Time Protocol” section of the Management chapter in the
Dell Networking OS Configuration Guide.
calendar set
Set the time and date for the switch hardware clock.
S5000
Syntax
calendar set time month day year
Parameters
time Enter the time in hours:minutes:seconds. For the hour
variable, use the 24-hour format; for example, 17:15:00 is
5:15 pm.
month Enter the name of one of the 12 months in English. You can
enter the name of a day to change the order of the display to
time day month year.
day Enter the number of the day. The range is 1 to 31. You can
enter the name of a month to change the order of the
display to time day month year.
year Enter a four-digit number as the year. The range is 1993 to
2035.
Command
Modes
EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You can change the order of the month and day parameters to enter the time and
date as time day month year.
In the switch, the hardware clock is separate from the software and is called the
calendar. This hardware clock runs continuously. After the hardware clock (the
calendar) is set, the Dell Networking OS automatically updates the software clock
after system bootup. You cannot delete the hardware clock (calendar).
System Time and Date
1331