Reference Guide

To disable multicast storm control on the interface, use the no storm-control
multicast packets_per_second in command.
Parameters
packets_per_se
cond in
Enter the packets per second of broadcast traffic allowed
into the network. The range is 0 to 33554431.
Defaults none
Command
Modes
INTERFACE (conf-if-interface-slot/port)
Command
History
Version 9.0(1.3) Introduced on the S5000.
storm-control unknown-unicast (Configuration)
Configure the percentage of unknown-unicast traffic allowed in or out of the network.
S5000
Syntax
storm-control unknown-unicast [packets_per_second in]
To disable storm control for unknown-unicast traffic, use the no storm-control
unknown-unicast [packets_per_second in] command.
Parameters
packets_per_se
cond in
Enter the packets per second of broadcast traffic allowed
into the network. The range is 0 to 33554431.
Defaults none
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Unknown Unicast Storm-Control is valid for Layer 2 and Layer 2/Layer 3 interfaces.
1328
Storm Control