Reference Guide

Parameters
packets_per_se
cond in
Enter the packets per second of broadcast traffic allowed
into the network. The range is 0 to 33554431.
Defaults none
Command
Modes
INTERFACE (conf-if-interface-slot/port)
Command
History
Version 9.0(1.3) Introduced on the S5000.
storm-control multicast (Configuration)
Configure the packets per second (pps) of multicast traffic allowed in to S5000 networks.
S5000
Syntax
storm-control multicast packets_per_second in
To disable storm-control for multicast traffic into the network, use the no storm-
control multicast
packets_per_second in command.
Parameters
packets_per_se
cond in
Enter the packets per second of multicast traffic allowed into
the network. The range is 0 to 33554431.
Defaults none
Command
Modes
CONFIGURATION (conf)
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Broadcast traffic (all 0xFs) should be counted against the broadcast storm control
meter, not against the multicast storm control meter. It is possible, however, that
some multicast control traffic may get dropped when storm control thresholds are
exceeded.
storm-control multicast (Interface)
Configure the percentage of multicast traffic allowed on an S5000 interface (ingress only) network only.
S5000
Syntax
storm-control multicast packets_per_second in
Storm Control
1327