Reference Guide

Usage
Information
You must reload the stack after entering the upgrade boot stack-unit
command to boot up stack units with the new boot code.
Example
Dell#upgrade boot bootselector-image stack-unit all booted
Password:
Current BootSelector information in the system:
===============================================================
Card BootSelector Current Version New Version
---------------------------------------------------------------
Unit0 Boot Selector 1.3.0.0m 1.3.0.0m
Unit7 Boot Selector 1.3.0.0m 1.3.0.0m
Unit8 Boot Selector 1.3.0.0m 1.3.0.0m
Unit9 Boot Selector 1.3.0.0m 1.3.0.0m
***************************************************************
* Warning - Upgrading boot selectors is inherently risky and *
* should only be attempted when necessary. A failure at this *
* upgrade may cause a board RMA. Proceed with caution ! *
***************************************************************
Proceed Boot Selector image for all units [yes/no]: yes
Programming
!.!.!.!.!!.!.!.!.!!.!.!.!.!.!.!!.!.!.!.!!.!.!.!.!.!!.!.!.!.!.!!
.!.
Bootselector image upgrade for all completed successfully.
Dell#
Dell#upgrade boot bootflash-image stack-unit all booted
Current BootFlash information in the system:
==============================================================
Card BootFlash Current Version New Version
--------------------------------------------------------------
Unit0 Boot Flash B 1.3.1.1o 1.3.1.1p
Unit7 Boot Flash B 1.3.1.1o 1.3.1.1p
Unit8 Boot Flash A 1.3.1.1o 1.3.1.1p
Unit9 Boot Flash A 1.3.1.1o 1.3.1.1p
***************************************************************
* Warning - Upgrading boot flash is inherently risky and *
* should only be attempted when necessary. A failure at this *
* upgrade may cause a board RMA. Proceed with caution ! *
***************************************************************
Proceed Boot Flash image for all units [yes/no]: yes
Programming
!!.!.!.!.!.!.!.!!.!.!.!.!.!!.!.!.!.!!.!.!.!.!.!!.!.!.!.!.!!.!.!
.!.!.!!.!.!.!.!.!!.!.!.!.!!.!.01:01:29: %STKUNIT7-M:CP
%SYSADM-5-CPU_THRESHOLD: Overall cpu usage of management-unit
is above threshold. Cpu1minUsage (89%)
01:01:29: %STKUNIT7-M:CP %SYSADM-5-TASK_CPU_THRESHOLD: 1min
cpu utilization of management-unit has exceeded the threshold.
Top three processes are sysdlp (79.79%), system (7.60%), sysd
(1.01%)
!.!.!.!!.01:01:34: %STKUNIT7-M:CP %SYSADM-5-CPU_THRESHOLD:
Overall cpu usage of stack-unit 10 is above threshold.
Stacking Commands
1319