Reference Guide

upgrade boot (stack unit)
Upgrade the boot image (bootflash or bootselector) on one or all stack units in an S5000 stack from the
master switch.
S5000
Syntax
upgrade boot {bootflash-image| bootselector-image} stack-unit
{stack-unit—id | all} {booted: | flash://file-path | ftp://
file-path | tftp://file-path | usbflash://file-path}
Parameters
boot Enter the keyword boot to change the boot image.
bootflash-
image
Upgrade the boot image in the bootflash partition.
bootselector-
image
Upgrade the boot image in the bootselector partition. You
are prompted to enter the password.
stack-unit
{stack-unit-id |
all}
Enter the keyword stack-unit: followed by the stack unit
ID of a member unit or all to upgrade the boot image on all
stack member units. Valid stack-unit ID numbers are 0 to 11.
booted: Upgrade the stack using the image with which the master
switch booted up.
flash: After the keyword flash:, enter the location of the source
file in the internal flash in the format: //file-pathname or
press Enter to launch a prompt sequence.
ftp: After the keyword ftp:, enter the location of the source file
in the format:
//userid:password@host-ip-address/
file-pathname or press Enter to launch a prompt
sequence.
tftp: After the keyword tftp:, enter the location of the source
file in the format:
//host-ipaddress/file—pathname or
press Enter to launch a prompt sequence.
usbflash: After the keyword usbflash:, enter the location of the
source file in the format:
//file-pathname or press Enter
to launch a prompt sequence.
file-path Enter the path and filename to be used to upgrade the boot
image.
Defaults none
Command
Modes
EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
1318
Stacking Commands