Reference Guide

Related
Commands
• reload – reboots Dell Networking OS.
• reset stack-unit – resets the designated S5000 stack member.
• show system – displays the current status of all stack members or a specific
member.
stack-unit stack-group
Configure the stack unit and stack group by specifying an ID when adding units to a stack to ensure the
unit is assigned to the correct group.
S5000
Syntax
stack-unit unit-number stack-group stack-group-number
To remove the current stack group configuration, use the no stack-unit unit-
number stack-group stack-number command.
Parameters
unit-number Enter the stack-unit number. The range is 0 to 11.
stack-group-
number
Enter the stack-group number. The range is 0 to 15.
Defaults none
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The following message displays to confirm the command.
WARNING: Setting ports Fo 0/60 as stack group will make their interface
configs obsolete after a reload.[confirm yes/no]: If “y” is entered, all non-
default configurations on this port (FortyGigE 0/60) will be removed when
the unit reboots.
Stacking Commands
1317