Reference Guide

Defaults None
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
• reload – reboots Dell Networking OS.
• show system – displays the status of all stack members or a specific member.
stack-unit renumber
Change the stack-unit number of any stack unit or a stand-alone S5000.
S5000
Syntax
stack-unit unit-number renumber unit-number
Parameters
unit-number
renumber
Enter the stack-unit number followed by the keyword
renumber. The range is 0 to 11. The first instance of this
value is the currently configured unit number of an S5000
switch. The second instance of this value is the new unit
number to be assigned to the switch.
Defaults none
Command
Modes
EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You can renumber any switch, including the management unit or a stand-alone
unit.
You cannot renumber a unit to a number of an active member in the stack.
When executing this command on the master, the stack reloads. When the
members are renumbered, only that specific unit is reset and comes up with the
new unit number.
Example
Dell#stack-unit 5 renumber 6
Renumbering will reset the unit.
Warning: Interface configuration for current unit will be lost!
Proceed to renumber [confirm yes/no]:
1316
Stacking Commands