Reference Guide

show config
Display the current configuration for the mode. Only non-default values are displayed.
S5000
Syntax
show config
Command
Modes
SPANNING TREE
Command
History
Version 9.0(1.3) Introduced on the S5000.
Example
Dell(config-stp)#show config
protocol spanning-tree 0
no disable
Dell(config-stp)#
show spanning-tree 0
Display the spanning tree group configuration and status of interfaces in the spanning tree group.
S5000
Syntax
show spanning-tree 0 [active | brief | guard | interface type
slot/port | root | summary]
Parameters
0 Enter 0 (zero) to display information about that specific
spanning tree group.
active (OPTIONAL) Enter the keyword active to display only active
interfaces in spanning tree group 0.
brief (OPTIONAL) Enter the keyword brief to display a synopsis
of the spanning tree group configuration information.
guard (OPTIONAL) Enter the keyword guard to display the type of
guard enabled on an STP interface and the current port state.
interface type
slot/port
(OPTIONAL) Enter the keyword interface and the type
slot/port of the interface you want displayed. Type slot/port
options are the following:
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
1302
Spanning Tree Protocol (STP)