Reference Guide

Command
Modes
SPANNING TREE (The prompt is “config-stp”.)
Command
History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
protocol spanning-tree – enters SPANNING TREE mode on the switch.
disable
Disable the spanning tree protocol globally on the switch.
S5000
Syntax
disable
To enable Spanning Tree Protocol, use the no disable command.
Defaults Enabled (that is, the spanning tree protocol is disabled.)
Command
Modes
SPANNING TREE
Command
History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
protocol spanning-tree – enters SPANNING TREE mode on the switch.
forward-delay
The amount of time the interface waits in the Listening state and the Learning state before transitioning
to the Forwarding state.
S5000
Syntax
forward-delay seconds
To return to the default setting, use the no forward-delay command.
Parameters
seconds Enter the number of seconds the Dell Networking OS waits
before transitioning STP to the Forwarding state. The range is
4 to 30. The default is 15 seconds.
Defaults 15 seconds
Spanning Tree Protocol (STP)
1299