Reference Guide

Defaults 6 or informational
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
To block a type of message parameter, set the logging trap level to a lower
number. For example, to block severity messages at level 6, set the level to 5.
Related
Commands
logging – enables the logging to another device.
logging on – enables logging.
show logging
Display the logging settings and system messages logged to the internal buffer of the switch.
S5000
Syntax
show logging [number | history [reverse][number] | reverse
[number] | summary]
Parameters
number (OPTIONAL) Enter the number of message to be displayed
on the output. The range is 1 to 65535.
history (OPTIONAL) Enter the keyword history to view only
information in the Syslog history table.
reverse (OPTIONAL) Enter the keyword reverse to view the Syslog
messages in FIFO (first in, first out) order.
summary (OPTIONAL) Enter the keyword summary to view a table
showing the number of messages per type and per slot.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Example
(partial)
Dell#show logging
Syslog logging: enabled
Console logging: level debugging
Monitor logging: level debugging
Buffer logging: level debugging, 50 Messages Logged, Size
(40960 bytes)
Trap logging: level informational
Logging to 172.16.1.162
Logging to 10.10.10.4
Logging to 10.1.2.4
1294
Simple Network Management Protocol (SNMP) and Syslog