Reference Guide

Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
• For Loopback interfaces, enter the keyword loopback
followed by a number from zero (0) to 16383.
• For the management interface, enter the keyword
ManagementEthernet followed by the slot/port
information. The slot range is 0 to 1 and the port range is
0.
• For a Port Channel interface, enter the keywords port-
channel followed by a number. The range is 1 to 128.
• For VLAN interface, enter the keyword vlan followed by
a number from 1 to 4094.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Syslog messages contain the IP address of the interface used to egress the router.
By configuring the logging source-interface command, the Syslog packets
contain the IP address of the interface configured.
Related
Commands
logging – enables logging to the Syslog server.
logging synchronous
Synchronize unsolicited messages and Dell Networking OS output.
S5000
Syntax
logging synchronous [level level | all] [limit number-of-
buffers]
To disable message synchronization, use the no logging synchronous [level
level | all] [limit number-of-buffers] command.
1292
Simple Network Management Protocol (SNMP) and Syslog