Reference Guide

Parameters
notification-
type
Enter the type of notification from the list below:
• bgp—Notification of changes in the BGP process.
• ecfm—Notification of changes to ECFM.
• envmon—For Dell Networking, device notifications when
an environmental threshold is exceeded.
• isis—Notification of intermediate service traps.
• lacp—Notification of changes.
• snmp—Notification of RFC 1157 traps.
• stp—Notification of a state change in the spanning tree
protocol (RFC 1493).
• vlt—Notification of virtual link trunking.
• vrrp—Notification of a state change in a VRRP group.
• xstp—Notification of a state change in MSTP (802.1s),
RSTP (802.1w), and PVST+.
notification-
option
For the envmon notification-type, enter one of the following
optional parameters:
• cam-utilization
• fan
• supply
• temperature
For the snmp notification-type, enter one of the following
optional parameters:
• authentication
• coldstart
• linkdown
• linkup
Defaults Not enabled.
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Dell Networking OS supports up to 16 SNMP trap receivers.
For the cam-utilization notification option, the system generates syslogs and
SNMP traps when the L3 host table or route table utilization goes above the
threshold.
If you do not configure this command, no traps controlled by this command are
sent. If you do not specify a notification-type and notification-option,
all traps are enabled.
1272
Simple Network Management Protocol (SNMP) and Syslog