Reference Guide

Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Sample-rate is the average number of packets skipped before the sample is taken.
This command changes the global default sampling rate. You can configure an
interface to use a different sampling rate than the global sampling rate. If the value
entered is not a correct power of 2, the command generates an error message
with the previous and next power of 2 value. Select one of these two packet
numbers and re-enter the command.
Related
Commands
sflow sample-rate (Interface) – changes the Interface sampling rate.
sflow sample-rate (Interface)
Change the Interface default sampling rate.
S5000
Syntax
sflow sample-rate value
To return to the default sampling rate, use the no sflow sample-rate
command.
Parameters
value Enter the sampling rate value. The range is 256 to 8388608
packets.
Defaults The Global default sampling.
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This command changes the sampling rate for an Interface. By default, the sampling
rate of an interface is set to the same value as the current global default sampling
rate. If the value entered is not a correct power of 2, the command generates an
error message with the previous and next power-of-2 value. Select one of these
two number and re-enter the command.
Related
Commands
sflow sample-rate (Global) – changes the sampling rate globally.
1262
sFlow