Reference Guide

sflow enable (Global)
Enable sFlow globally.
S5000
Syntax
sflow enable
To disable sFlow, use the no sflow enable command.
Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
sFlow is disabled by default. In addition to this command, sFlow needs to be enable
on individual interfaces where sFlow sampling is desired.
Related
Commands
sflow enable (Interface) – enables sFlow on Interfaces.
sflow enable (Interface)
Enable sFlow on Interfaces.
S5000
Syntax
sflow enable
To disable sFlow, use the no sflow enable command.
Defaults Disabled.
Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
When you enable sFlow on an interface, flow sampling is done on any traffic going
out of the interface.
NOTE: After a physical port is a member of a LAG, it inherits the sFlow
configuration from the LAG port.
Related
Commands
sflow enable (Global) – turns sFlow on globally.
sFlow
1259